Page 14
INTRODUCTION
7. Cylinder head installation requires lowering
the head onto the gasket, then pulling the
head horizontally against the timing gear
mounting plate using through screws.
Pressed bosses in the gasket keep the head
from making full contact with the gasket
surface and prevent damage to the rubber
sealing rings as the head slides into
position.
8. DO NOT use ether or similar types of
starting aids.
Use of ether or similar types of starting aids in
MACK US07 emission compliant engines is
strictly prohibited. This applies to engines
with or without the electric pre-heater option.
An explosion could occur. Failure to heed this
danger may result in severe personal injury or
death.
9. The MP7 engine uses a number of O-rings
for sealing various fluid joints and tubes. It is
essential that new O-rings of the correct
material be used whenever joints are
disassembled and reassembled.
10. Mark the alignment of the sections before
disassembling the particulate filters.
To Next Page
Loading...
