Page 262
REPAIR INSTRUCTIONS, PART 2
Ensure that the three valve housing seal rings are
properly placed when mounting the housing on
the cylinder block.
12. Inserting the pressure side pipe and
assemble the valve housing on the cylinder
block.
13. Using a torque wrench, tighten the screws in
sequence according to specification.
14. Assemble the inlet pipe in the oil pump
housing.
15. Depending on usage:
앫 Attach the short pipe and strainer to the
bracket.
앫 Attach the long pipe and strainer to the
valve housing assembly.
16. Using a torque wrench, tighten the screws
according to specification.
17. Lubricate and assemble a new seal on the
oil pan.
18. Attach the oil pan to the cylinder block.
19. Using a torque wrench, tighten the screws in
sequence according to specification.
376
Figure 376 — Oil Filter Housing
20. Using a tee fitting with the pressure sensor,
check system oil pressure through the
pressure sensor port (M18) in the oil filter
housing.
The engine will shut down if operation is
attempted without the pressure sensor.
1. Full-Flow Filter By-Pass
Valve
2. Oil Pressure Sensor Port
(M18 Thread)
3. Piston Cooling Valve
4. Main Oil Gallery
Regulator Valve
5. Oil Cooler By-Pass Valve
To Next Page
Loading...
