REPAIR INSTRUCTIONS, PART 2
Page 267
385
Figure 385 — Lubricating Sector Gear Teeth
6. Carefully remove the alignment pin, taking
care not to move the sector gear.
386
Figure 386 — Removing Alignment Pin
7. Connect the actuator electrical connector to
the engine harness connector. Install tie
straps as needed to secure the harness.
8. Install all previously removed cables to the
ground (negative) battery terminals.
9. Connect the VCADS pro PC or the Tech Tool
to the vehicle diagnostic connector, and turn
the vehicle ignition switch to the ON position.
10. Using VCADS pro or Tech Tool, command
the actuator to the Install position. Turn OFF
the ignition when done. The actuator is now
ready for installation.
Keep hands and obstructions away from the drive
gear during installation. The actuator gear must
not be moved or the calibration will not be
successful.
11. Insert two new attaching screws diagonally
in the SRA.
Use new attaching screws and a new gasket
when assembling the SRA on the turbocharger.
387
Figure 387 — Attaching SRA to Turbocharger
12. Assemble a new gasket on the protruding
screws at the back of the actuator.
13. Carefully align the actuator with the
turbocharger center housing and place the
actuator in position on the turbocharger.
Hand tighten the two attaching screws.
Be careful to preserve the gear tooth alignment
and the correct position of the gasket during
assembly.
1. SRA Housing
2. Attaching Screws
3. Gasket
To Next Page
Loading...
