Page 302
SPECIFICATIONS
FITS AND LIMITS
The specifications as listed are for new parts and,
therefore, maximum wear must be established by
good judgment, experience and sound shop
practice.
Oil Filters 2 full-flow; 1 by-pass
Filter capacity, 2 full-flow plus 1 by-pass:
앫 6 L (6.3 qts.)
Oil Pan Aluminum; 18 spring-tension screws
Sump capacity:
앫 25 L (26.4 qts.) minimum
앫 30 L (31.7 qts.) maximum
Thermostat Piston-type; 82°C (180°F) to 92°C (198°F)
Thermostat Housing Integrated in head
Timing Gear Cover Die-cast aluminum, elastomer seals
Variable Geometry Turbocharger (VGT) Holset; exhaust-driven; fixed vanes; sliding ring nozzle;
infinitely variable volume; oil-lubricated and water-cooled
Valve Lifters Roller followers
Valve Seat Inserts Pressed in head, replaceable
Vibration Damper — Camshaft Fluid filled
Vibration Damper — Crankshaft Fluid filled
Item Description
Tolerances Are Shown Low to High Standard Size or Fit
Component Metric English
CAMSHAFT
Camshaft Journal Diameter 69.97–70.00 mm 2.7547–2.7559 in.
Inlet Valve Lobe Nominal Lift 13.1 mm 0.516 in.
Exhaust Valve Lobe Nominal Lift (with Engine Brake) 13.1 mm 0.516 in.
Camshaft End Play 0.24 mm max. 0.0094 in. max.
CONNECTING ROD
Connecting Rod Journal to Bearing Clearance 0.102 mm max. 0.004 in. max.
Side Clearance 0.35 mm max. 0.014 in. max.
Length between Centers 225 mm 8.8583 in.
Twist (within 100 mm [3.937 in.]) 0.15 mm max. 0.0059 in. max.
Bend (within 100 mm [3.937 in.]) 0.06 mm max. 0.0024 in. max.
CRANKSHAFT
End Play (lubricated parts) 0.15 mm 0.0059 in.
Crankpin Journal OD
(Inspection only: not for machining)
88 mm 3.4646 in.
Main Journal OD
(Inspection only: not for machining)
108 mm 4.2520 in.
Journal Out-of-Round (maximum) 0.01 mm 0.0004 in.
Journal Taper (maximum) 0.01 mm 0.0004 in.
To Next Page
Loading...
