SPECIFICATIONS
Page 309
MP7 ENGINE COMPONENTS — TOP OF ENGINE
Cylinder Head (Valve) Cover
437
Figure 437 — Cylinder Head Cover Torque Sequence
Camshaft Bearing Caps and Rocker Arm Shaft Assembly
438
Figure 438 — Rocker Arm Shaft Assembly Installation
The rocker arm shaft assembly is installed on top
of the camshaft bearing caps (inboard side) using
the long screws, numbers 8 through 14. The
rocker arm shaft and camshaft bearing cap
retaining screws are tightened to specification in
seven steps as listed in the following table.
Tighten screws in the order indicated 24 ±4 N•m (18 ±3 lb-ft)
To Next Page
Loading...
