SPECIFICATIONS
Page 317
Timing Gears
448
Figure 448 — Torque Sequence Screw Numbers — Gear Mounting
Component Torque Plus Angle Tighten
Loosen any screws used to pull the cylinder head into position before beginning this sequence.
Tighten screws in the order indicated on each gear.
(A) Crankshaft Gear (2 screws) 24 ±4 N•m (18 ±3 lb-ft)
(B) Intermediate Idler Gearset Hub (6
screws)
25 ±3 N•m (18 ±2 lb-ft) 110° ±5°
(C) Adjustable Idler Gear Hub (5
screws)
35 ±4 N•m (26 ±3 lb-ft) 120° ±5°
(D) Camshaft Gear and Damper (6
screws)
45 ±5 N•m (33 ±4 lb-ft) 90° ±5°
To Next Page
Loading...
