Page 320
SPECIFICATIONS
453
Figure 453 — Torque Sequence Screw Numbers — Housing to Plate
Additional Rear of Engine Components
Hold the engine with the flywheel end uppermost for this procedure.
In the order indicated, tighten the screws to the following torque values.
Note: Screw No. 1 is 120 mm (4.7 inches) long and screw Nos. 2 through 11 are 100 mm (3.9 inches) long. Use care to
ensure that the longer screw is installed in the correct position.
Step 1. Screws 1–11 (M12 and M14) 24 ±4 N•m (18 ±3 lb-ft)
Step 2. Screws 8–11 (M12) 85 ±15 N•m (63 ±11 lb-ft)
Step 3. Screws 1–7 (M14) 140 ±15 N•m (103 ±11 lb-ft)
Attaching Screws, Rear Engine Support 300 ±30 N•m (221 ±22 lb-ft)
Rear Engine Mounting Pad M20 500–555 N•m (370–410 lb-ft)
Rear Engine PTO 85 ±5 N•m (63 ±11 lb-ft)
To Next Page
Loading...
