Page 322
SPECIFICATIONS
456
Figure 456 — Torque Sequence Screw Numbers — Oil Pan to Block
Additional Bottom of Engine Components
Tighten screws in the order indicated 24 ±4 N•m (18 ±3 lb-ft)
Block Stiffener Plate
Attaching Screws, M10 (16) Hand start all, then tighten to 48 ±8 N•m (35 ±6 lb-ft).
Oil Valve Housing
Attaching Screws (4) Hand start all, then tighten to 48 ±8 N•m (35 ±6 lb-ft).
Crankshaft Bearing Caps
Discard screws with four marks when removed and substitute new screws.
Attaching Screws
Step 1. 150 ±20 N•m (111 ±15 lb-ft)
Step 2. Angle tighten 120° ±5°
Connecting Rod Bearing Caps
Discard screws with four marks when removed and substitute new screws.
Tighten screws in a cross pattern.
Attaching Screws
Step 1. 30 ±3 N•m (22 ±2 lb-ft)
Step 2. Angle tighten 180° ±6°
Oil Pan Drain Plug 60 ±5 N•m (44 ±4 lb-ft)
Oil Pan Fill Adapter Screws 24 ±4 N•m (18 ±3 lb-ft)
Dipstick Attaching Screw 10 ±1 N•m (7 ±1 lb-ft )
Oil Pump Attaching Screws 24 ±4 N•m (18 ±3 lb-ft)
Strainer/Pickup Pipe 24 ±4 N•m (18 ±3 lb-ft)
Nozzle Attaching Screws, Piston Cooling
Do not reuse.
24 ±3 N•m (18 ±2 lb-ft)
To Next Page
Loading...
