M A E D A Mini-Crawler Crane Section 4 – RADIO REMOTE CONTROL SYSTEM INTRODUCTION
9/2020 MC285CB-3 4-89
8. Stow the power supply cable.
Fig. 4-216
NOTICE: The power supply cable can be stored
inside the inspection door.
RADIO REMOTE CONTROL
SYSTEM INTRODUCTION
This section describes the radio remote control
system operating procedures. Before you perform
any radio remote control system operating
procedures, see “Section 2 SAFETY.”
Upon using the radio remote control system, also
see HBC Operation Manual.
General
Modification
WARNING! Electrical Shock Hazard. Do not
dissemble or modify the transmitter, receiver
or accessories. Damage to the components
may result in electrical failure.
Fig. 4-217
Holding
Wear the waist belt, and operate the control levers
and buttons with your thumb. Firmly grasp the grip
with other fingers and hold the transmitter.
Fig. 4-218
Always manipulate levers and switches with your
fingers.
To Next Page
Loading...
