M A E D A Mini-Crawler Crane Section 4 –HANDLING TRANSMITTER BATTERY
9/2020 MC285CB-3 4-117
Inspection after Ending Remote
Control System Operation
1. Inspect the transmitter and receiver after
ending remote control system operations.
a. Check operation levers and switches of
the transmitter for any faults.
b. Wipe off oil or dirt with a clean cloth.
c. Repair all cracks or damages without fail.
2. To store the transmitter, avoid places subject
to wind, rain, direct sunlight, high
temperatures and high humidity.
HANDLING TRANSMITTER
BATTERY
NOTICE: The battery used for the transmitter is an
exclusive battery.
Replacement Timing of Battery
If the battery runs low, recharge the battery or
replace the battery with a charged battery.
If the battery is not replaced, the transmitter will
stop in a few minutes.
Fig. 4-294
Replacement Method of Battery
Replace the battery of the transmitter in the
procedure described below.
1. Turn OFF the power of the transmitter.
Pressing the Emergency Stop (EMO)/
Transmitter Power OFF Switch will turn OFF
the power.
Fig. 4-295
2. Lift the battery upward while pushing it. The
battery comes off.
Fig. 4-296
To Next Page
Loading...
