Section 4 – STARTING Mini-Crawler Crane M A E D A
4-26 9/2020 MC285CB-3
STARTING
Before starting the machine, see “Pre-Start
Inspection” on page 5-16.
WARNING! The following safety messages
address a potential Entanglement Hazard
while starting the machine:
• Verify there are no people or obstacles near
the machine before starting the machine.
Sound the horn as a warning before starting
the machine. Be sure the area is clear of
people and obstacles before starting the
machine.
• Verify that all machine guards and covers are
attached properly to the machine before
starting the machine. Do not start the machine
if any guards or covers are not properly
installed on the machine.
• Do not operate or carelessly contact the
travelling levers while starting or operating the
machine. Only operate the correct controls per
the operation.
• Always turn the Starter Switch to the OFF
position after operation is complete and
remove the key from the switch. Keep the key
in your possession when the machine is not
operating.
CAUTION: Only use the starting procedure
as described in this manual to start the
machine.
Starting the Machine
Before starting the machine, make sure no
personnel or impediments are close to the
machine and honk the horn.
59BCAUTION: Verify that the radio remote
control system is “OFF”.
NOTICE: If the machine does not operate, check
the battery charge level and the state of the
disconnect switch.
Insert the key into the starter switch and turn the
key to the "ON" position.
Fig. 4-58
To Next Page
Loading...
