Maintenance work on the carrier
7.4 Fuel system
7 - 36 3 302 574 en Maintenance manual
GMK3060
03.11.2017
• Remove the electrical connecting cable (3)
from the water sensor (WIF = Water in Fuel).
• Remove the filter (1).
• Screw on a new filter (1) and tighten it.
• Close the valve (2) manually.
• Attach the electrical connecting cable (3) to
the water sensor (WIF = Water in Fuel).
• Actuate the pump (2) until the fluid flowing
out of the drain plug (1) no longer contains
any bubbles.
• Close the drain plug (1).
• Start the engine and check for leaks.
• Remove the receptacle.
H
If you have used a clean receptacle, you can refill the fuel tank with the
consumable using a filter.
Otherwise dispose of the consumable properly.
To Next Page
Loading...
