Manitowoc GROVE GMK 3060 - Axle Centre Drives - Checking the Oil Level; Axle Lines; General Inspection

Maintenance work on the carrier
7.7 Axle lines
03.11.2017
Maintenance manual 3 302 574 en 7 - 51
GMK3060
7.7 Axle lines
• Comply also with the running-in instructions; à p. 4 - 1.
7.7.1 General inspection
• Investigate any unusual running noises from the axle centre drives and
the final drives.
• Check the axle centre drives/final drives and the connections for leaks. If
consumables are leaking;
à Axle centre drives – checking the oil level, p. 7 - 51,
à Final drives - Checking the oil level, p. 7 - 55.
• Check that pipes and hoses are tightly connected and undamaged.
If any damage is found, report it to
Manitowoc Crane Care or an authorised
GROVE dealer or an authorised specialist workshop.
7.7.2 Axle centre drives – checking the oil level
Spare parts
and tools
1)
Additional equipment (1st axle line driven)
Prerequisites – The truck crane must be raised on outriggers or parked over an inspection
pit.
– The engine must not be running and must be secured against unauthor-
ised use;
à p. 2 - 3.
s
W
M 1
for drive Designation Quantity GROVE part no.
6 x 4 x 6
Gasket 30 x 36 Cu DIN 7603
2 00117151
Gasket 24 x 29 Cu DIN 7603 1 00117145
6 x 6 x 6
1)
Gasket 30 x 36 Cu DIN 7603
3 00117151
Gasket 24 x 29 Cu DIN 7603 1 00117145