Manitowoc GROVE GMK 3060 - Check the Oil Level; Engine

Maintenance work on the carrier
7.3 Engine
03.11.2017
Maintenance manual 3 302 574 en 7 - 15
GMK3060
7.3 Engine
• Also carry out the additional maintenance work specified in the Engine
manufacturer's documentation
supplied.
7.3.1 Check the oil level
Prerequisites – The truck crane must be level.
Check the oil level
• After switching on the ignition, wait until the pre-heating lamp (1) on the
instrument panel goes out.
• Start the engine.
• Switch off the engine immediately, if
– The lamps (2) or (3) on the instrument panel remain lit for longer than
10 seconds,
– and the warning buzzer sounds.
If the lamp (2) remains lit then an engine fault is present and you must have
the error read.
• Allow the engine to run at idling speed for 2 - 3 minutes.
• Switch the engine off.
• Check the oil level after a few minutes.
s
D
S
Risk of damage to the engine if the oil pressure is too low!
Switch off the engine immediately if the lamps (2) or (3) on the instrument
panel light up.
Running the engine when the oil pressure is too low can damage it.