Maintenance work on the superstructure
8.9 Cable drums and slewing angle sensor
8 - 62 3 302 574 en Maintenance manual
GMK3060
03.11.2017
8.9.2 Lubricating the slewing angle sensor
Grease, spare
parts, tools
– Grease gun from the tool set.
– Sealing agent (e.g. Hylomar).
– Torque wrench for 25 Nm (18.5 lbs ft).
Prerequisites – The engine must not be running and must be secured against
u
nauthorised use;
à p. 2 - 3.
Greasing
• Unscrew the screw (1).
• Clean the grease nipple (2) and inject about
5 cm³ (0.3 in³) of grease.
• Remove any excess grease, and close the
grease nipple.
• Tighten the screw with a new gasket and
sealing agent – torque 25 Nm (18.5 lbs ft).
Lubricating
grease
Designation
to DIN 51502
Specification
Classification
GROVE part no.
Grease KP - 1K - 50 DIN 51825 03233369
Designation Quantity GROVE part no.
Gasket 16 x 20 Cu DIN 7603 1 00117134
S
Risk of damage to the slewing angle sensor!
Before lubricating, always remove the screw from the slewing angle
sensor.
This prevents the slewing angle sensor from damage.
To Next Page
Loading...
