Manitowoc GROVE GMK 3060 - Final Drives - Checking the Oil Level

Maintenance work on the carrier
7.7 Axle lines
03.11.2017
Maintenance manual 3 302 574 en 7 - 55
GMK3060
7.7.4 Final drives - Checking the oil level
Spare parts
and tools
1)
Additional equipment (1st axle line driven)
Prerequisites – The truck crane must be raised on outriggers and must be level.
– The engine must not be running and must be secured against unauthor-
ised use;
à p. 2 - 3.
– The parking brake must be released.
Checking
the oil level
• Check the oil level at all other final drives in
the same way.
• Turn the wheel until the marking (2) is hori-
zontal and is on the right, next to the centre
of the axle.
• Unscrew the screw (1).
• Check that the oil level is at the mark (2).
• Fit a new gasket and tighten the screw.
If the oil level is too low
• Top up with oil; à p. 7 - 57.
M 1
for drive Designation Quantity GROVE part no.
6 x 4 x 6 Gasket 24 x 30 Cu DIN 7603 4 04181265
6 x 6 x 6
1)
Gasket 24 x 30 Cu DIN 7603 6 04181265