Manitowoc GROVE GMK 3060 - Lubricating the Gear Teeth

Maintenance work on the superstructure
8.5 Slewing bearing
03.11.2017
Maintenance manual 3 302 574 en 8 - 27
GMK3060
8.5.2 Lubricating the gear teeth
Grease
H
Observe the instructions and safety instructions on the adhesive lubricating
grease packaging!
Prerequisites – The truck crane is level and on outriggers;
à Operating Instructions.
– The main boom must be fully raised;
à Operating Instructions.
– The engine must not be running and must be secured against
unauthorised use;
à p. 2 - 3.
Greasing A distinction is made between initial lubrication and subsequent
lubrications.
A distinction is made between initial lubrication an
d subsequent
lubrications:
s
M 6
Designation Quantity GROVE part no.
Adhesive lubricating grease
(spray can)
1 00554205
G
Risk of crushing from the gear teeth!
Fingers may be crushed or clothing can be drawn into the open, rotating
pinion. For this reason, be sure to remount the plate after lubricating.