Maintenance work on the carrier
7.6 Transmission
03.11.2017
Maintenance manual 3 302 574 en 7 - 49
GMK3060
Prerequisites – The gear oil must be at operating temperature (70 to 95 °C (160 to 200 °F)).
– The truck crane must be raised on outriggers or parked over an inspection
pit.
– The truck crane must be level.
– The
engine must not be running and must be secured against unauthor-
ised use;
à p. 2 - 3.
Draining oil
• Place a container under the drain plugs (2).
• Unscrew the drain plugs (1) and (2) and
allow the oil to drain.
• Clean the drain plugs.
• Replace the gasket and tighten the drain
plugs (2) – torque 60 Nm (44.2 lbf ft).
s
G
Risk of scalding from gear oil at operating temperature!
You could scald yourself by gear oil escaping in an uncontrolled manner at
operating temperature. Wear appropriate protective gloves and take care
not to come into contact with the gear oil.
O
Risk of environmental damage due to leaking consumables!
Always let consumables drain into suitable receptacles. Wipe up any con-
sumables that escape.
Store/dispose of consumables and any so
aked equipment properly.
Ask about the applicable regulations.
To Next Page
Loading...
