Maintenance work on the carrier
7.13 Hydraulic system
03.11.2017
Maintenance manual 3 302 574 en 7 - 95
GMK3060
Draining oil
The superstructure is slewed to the rear.
• Place a receptacle underneath the valves.
• One after the other, screw the connecting
piece and hose onto the valves (1), (2)
and (3);
à Handling the valves, p. 7 - 94.
• Change the filters; à p. 7 - 98.
Topping up the oil
The superstructure is slewed to the rear so
that the cover (2) is accessible.
• Remove the cover (2).
• Add new oil through a filter until the level
reaches the centre of the sight glass (1).
• Replace the gasket if necessary and fasten
the cover.
s
O
Risk of environmental damage due to leaking consumables!
Use the supplied connecting piece and hose and a receptacle with sufficient
capacity to drain the hydraulic oil.
S
Risk of damage to the hydraulic system!
Cleanliness is of the utmost importance when handling hydraulic oil.
Even fresh hydraulic oil must be filtered before it is added to the tank.
To Next Page
Loading...
