Maintenance work on the superstructure
8.14 Other maintenance work
8 - 78 3 302 574 en Maintenance manual
GMK3060
03.11.2017
Spraying
• Make sure that you do not spray running
surfaces. There is a risk of slipping!
• Spray the corrosion protection with a spray
gun aimed only at the pumps, valve blocks,
screw connections, pipes, hoses of the
hydraulic system of the superstructure:
– On the slewing gear (1),
– On the slewing duct (2),
– On the derricking cylinder (3),
– On the hoists (4).
• Clean surfaces sprayed by accident
immediately with water.
• Let the corrosion protection dry for one hour.
• Check that a transparent waxy protective film has covered the entire
surface.
G
Risk of injury to the eyes!
While working with the spray extension you could be hit by the spray jet or
spray droplets. Wear protective goggles, protective clothing and gloves.
To Next Page
Loading...
Need help?
General
