Installation and User Manual
19
4.1.1.6 Contaminating agents
The electrical components have been adequately protected against the infiltration of solid and liquid bodies
for the intended use of the P3UP and the environment that the P3UP is used in.
Unless otherwise stated in the contract, the electrical components DO NOT have specific protections against
contaminating agents such as dust, liquids, acids, corrosive gases, salt, etc.
If using electrical components and the complete equipment in environments subject to such contaminating
agents contact Marposs immediately. Marposs will check the suitability of the assembly based on the
environments they are used in.
4.1.1.7 Ionizing and non-ionizing radiation
The electrical components DO NOT additional protections against radiation such as microwaves, ultraviolet
rays, laser or X-rays.
If the P3UP is exposed to radiation, additional measures must be implemented to prevent to incorrect
operation of the components and their early deterioration.
4.1.1.8 Lighting of a 'normal' environment
The installation operations must be performed in ‘normal’ light conditions, so that the operator is not dazzled
or the operator must not strain his eyesight with poor lighting.
The P3UP installers must comply with the minimum requirements set out by the applicable laws in the
respective countries in terms of natural and artificial lighting of the premises.
If there is poor lighting in the work place the operator must use portable lighting equipment.
4.1.1.9 Removing the P3UP from its packaging
Marposs has not stipulated and special equipment to be used when removing the P3UP from its packaging.
The operator must proceed carefully and avoid carrying out any actions that might damage the P3UP or any
of its components.
Handle with care: Static sensitive components.
Before acces
sing the front panel, operators must make sure they have eliminated any
accumulated electrostatic charges by touching a metallic surface that is connected to the
To Next Page
Loading...
