marposs P3UP - 7.3.2.2 CONTROLS Parameter Setup

Installation and User Manual
75
7.3.2.2 CONTROLS
This parameter can be used to define the number of active grinder advance controls.
1. Press
to display any modifications to
the CONTROLS parameter;
2. Rotate the knob to set-up the number of
controls:
• C4 = n°4 controls + zero control;
• C3 = n°3 controls + zero control;
• C2 = n°2 controls + zero control;
• C1 = n°1 controls + zero control;
•
C0 = zero control only (final dimension
reached)
3. Press
to confirm and return to the
programming menu; or
to return to
the programming menu without confirming.
[
N.B.
Depending on the type of I/O module installed (I/O TYPE A;, I/O T
YPE B, I/O TYPE C, see
para.6.3) and the factory configuration, the maximum number of controls may be less than 4
controls + zero control.