Installation and User Manual
95
9.
ROUTINE MAINTENANCE
9.1
Cleaning the machine
To clean the external part of the electronic unit and the front panel, use a damp, static-free cloth.
WARNING
DO NOT USE SOLVENTS OR ABRASIVE PRODUCTS.
9.2
Cleaning the heads
Clean the heads using a soft cloth at regular intervals, depending on the operating conditions, taking care to
avoid damaging any rubber seals and output cables.
WARNING
DO NOT USE SOLVENTS OR ABRASIVE PRODUCTS.
9.3
Replacing the knob
If it is necessary to replace the knob, proceed as follows:
1. Remove the cap at the top of the knob using a flat head screw drive in order to expose the nut.
2. Unscrew the nut and remove the knob.
3. Remove the knob and replace it with an identical one. (Marposs part numbers, knob: 4129000047; cap:
4129000048).
4. Secure the new knob with the nut (supplied) so that it can still be rotated when pressed.
5. Fit the cap.
9.4
Extraordinary maintenance
WARNING
The extraordinary maintenance operations may only be carried out by authorised personnel.
To Next Page
Loading...
