marposs P3UP - 6.7 Measurement Head Mechanical Zero-Setting; 6.7.1 Mechanical Zero-Setting In-Process Heads with Adjustment Guides

Installation and User Manual
50
6.7 Measurement Head Mechanical Zero-Setting
Mechanically zero-set the measurement heads with P3UP in MANUAL MODE.
The individual In-Process measurement head channels can be displayed by selecting channel T1 or T2
6.7.1 Mechanical zero-setting In-Process heads with adjustment guides
• Measurement head with two ball probes
Figure 12: Measurement head with two ball probes
• Unimar measurement heads with ball probes
Figure 13: UNIMAR measurement heads with ball probes
Head
Support Unit
Head Support
Unit