marposs P3UP - Page 6

Installation and User Manual
6
7.2.6.5 Memory for planes (with internal synchronisation) 69
7.2.6.6 Memory for planes (with I/O synchronisation) 69
7.2.6.7 Stock removal estimate memory 70
7.2.6.8 Dynamic signal processing (DYN LED) 71
7.3 P3UP IN SET-UP 72
7.3.1 ACCESSING THE PROGRAMMING MENU (PROG) 72
7.3.2 SETTING UP THE PROGRAMMING PARAMETERS (P3UP IN-PROCESS) 74
7.3.2.1 IP DELAY 74
7.3.2.2 CONTROLS 75
7.3.2.3 C-1 EN 76
7.3.2.3.1 C-1 76
7.3.2.4 TIP t1 and TIP t2 (optional) 77
7.3.2.5 FBK STEP 77
7.3.2.6 FBK RST 78
7.3.2.7 ADJ MODE 78
7.3.2.8 ADJ INCR 79
7.3.2.9 ADJ SPED 79
7.3.2.10 DLY RTEN 80
7.3.2.11 RET t1 and RET t2 (optional) 81
7.3.2.12 A M SAFE 82
7.3.2.13 DEFAULT 83
7.3.2.14 P3UP VERSION 83
7.3.2.15 DISPLAY 84
7.3.3 SETTING UP THE PROGRAMMING PARAMETERS (P3UP WITH MEMORY) 85
7.3.3.1 Damping Memory 85
7.3.3.2 Continuous sampling memory 86
7.3.3.3 Memory for planes 86
7.3.3.4 Stock removal estimate memory 87
7.3.4 CLOSING THE PROGRAM MENU 88
7.3.5 PROGRAMMING PARAMETERS SUMMARY TABLE 89
8. DIAGNOSTICS AND MAINTENANCE 93
8.1 ALARMS AND WARNINGS 93
9. ROUTINE MAINTENANCE 95
9.1 CLEANING THE MACHINE 95
9.2 CLEANING THE HEADS 95
9.3 REPLACING THE KNOB 95
9.4 EXTRAORDINARY MAINTENANCE 95