marposs P3UP - Zero Mode Execution

Installation and User Manual
65
[
NOTE
It is possible to reset the ZADJ values by pressing and simultaneously
ZERO MODE
Press
to access the ZERO mode;
If the zero is executed
The ZERO OK
appears for 2 seconds, then the
P3UP calculates automatically the correction value
and displays it briefly by flashing it. Then ADJ
RNG and ±500 µm appears on the display.
If the zero is not executed
the P3UP displays the message ZERO OVR

ADJ RNG

±500 µm

ZERO OVR
on the
display and sets the maximum correction possible
(± 100µm or ±0.005”
based on the unit of
measurement displayed)