marposs P3UP - Page 92

Installation and User Manual
92
[
*N.B.
Available in AUTOMATIC MODE only if ADJ MODE=Free mode is selected.
**N.B.
If the DYN SAFE safety is active and the P3UP is in Automatic mode, it is not possible exit the
dynamic measurement mode. This function is a factory pre-
set and may be deactivated if
requested by the customer.
***N.B.
If the SUM SAFE safety is active and the P3UP is in Automatic mode it is not possible t select
T1 and T2. This function is a factory pre-
set and may be deactivated if requested by the
customer.
WARNING
For safety reasons, it is only possible to modify a limited number of parameters while in
AUTOMATIC MODE.