MLA System USER GUIDE
MLA System User Guide V2.1 395
As with MLA you need to enter the angles specified by your Display 2.1 project. There is a cell showing all “legal"angles available;-
Angles are then entered in the main table including the grid angle. For each cabinet entry, an angle between 0.5 and 10 will show
“MLA Cabinet"in the Cabinet column, entering a zero will leave a blank in the column;-
The cells on the right hand side display all the rigging information. First is the number of cabinets and Distro breakout boxes;-
The total weight of the array is shown;-
The closest hole to achieve the required angle for a single point lift is displayed. As with MLA, this angle should be entered into
Display 2.1 over-writing the calculated angle and the EQ optimisation re-calculated to get the most accurate results possible
using the actual angle that the array;-
Dual point suspension is also displayed with load on each point in both kilograms (kg) and pounds (lbs);-
To Next Page
Loading...
