MLA System USER GUIDE
MLA System User Guide V2.1 40
to 125 metres between network ports. U-Net protocol uses a redundant ring fault tolerance so connections “daisy-
chain"between all units in the network going from port 1 on the first unit to port 2 on the next and so on before finally making a
return connection back to port 2 on the first unit to complete the loop. Ready-made tour-grade network cables in a variety of
lengths from short inter-cabinet patching to long front of house to stage are supplied as part of an MLA system.
Audio wiring is the industry standard for balanced connections;-
Pin 1. Ground or shield
Pin 2 +, Hot, in phase
Pin 3 -, Cold, out of phase.
The signal source used to feed the MLA array must have line drive capabilities suitable for driving the combined load of the entire
array.
AES/EBU output connections are identical to analogue but cable used must be a dedicated 110Ω, low capacitance digital cable
such as Belden 1800F or 1696A.
Essential Maintenance
Coming Soon
Tools Required
Coming Soon
Replacing the amplifier module
Coming Soon
Replacing a mid driver
Coming Soon
Replacing a compression Driver
Coming Soon
Replacing a Diaphragm
Coming Soon
To Next Page
Loading...
