20.2 Introducing acquisition / recording possibilities 175
13. Finally, save the "Sequencer Set" (green box, figure 3): "int SequencerSetSave()".
14. Leave the "Configuration Mode" (red box, figure 4: "Sequencer Configuration Mode" = "Off".
15. Activate the "Sequencer Mode" (red box, figure 4): "Sequencer Mode" = "On".
Figure 6: wxPropView - "Sequencer Mode" = "On"
Note
The "Sequencer Mode" will overwrite the current device settings.
MATRIX VISION GmbH
To Next Page
Loading...