212 CONTENTS
Figure 16: After adapting contrast
Figure 17: Corresponding histogram after adapting contrast
20.3.2.4 Step 4: Saturation and Color Correction Matrix (CCM)
Still saturation is missing. To change this, the "Color Transformation Control" can be used ("Setting -> Base ->
Camera -> GenICam -> Color Transformation Control"):
1. Click on "Color Transformation Enable" and
2. click on "Wizard" to start the saturation via "Color Transformation Control" wizard tool (since firmware version
1.4.57).
MATRIX VISION GmbH
To Next Page
Loading...