60-58 Maintenance - As Required VX30/VX50 Gen3/ECO50 Vacuum Systems
• Rotate blower shaft (10–25 turns) weekly during storag
e. Inspect the blower shaft near shaft seal area
monthly, and spray with rust inhibitor if needed.
• For long term storage (over six months), contact blower manufacturer Customer
Service for
recommendations.
Removing from Storage
• Inspect internals to ensure absence of rust.
• Remove all protective coverings.
• Drain any water and sediment from fuel tank.
Fill fuel tank.
• Check battery fluid level, charge battery, and install in machine.
• Refer to the Engine Operation Manual supplied w
ith machine for restoring engine to operation.
• Refer to the Blower Operation Manual suppli
ed with machine for restoring blower to operation.
• Refer to the Pump Operation Manual supplied with machine
for restoring water pump to operation.
• Lubricate all grease points on the machine.
• Refer to this Maintenance section for additi
onal service points.
To Next Page
Loading...
