3A-16 - FUEL SYSTEMS 90-817643R1 DECEMBER 1996
• Install main jet.
• Install main jet plug and gasket.
51116
b
a
a - Main Jet [Torque 14 lb. in (1.6 N·m)]
b - Main Jet Plug and Gasket [Torque 22 lb. in. (2.5 N·m)]
• Install stem gasket.
• Install fuel bowl gasket.
51119
b
a
a - Stem Gasket
b - Fuel Bowl Gasket
NOTE: If Spring Clip on Inlet Needle was removed, or if
needle was replaced, be sure spring clip is reattached.
• Attach Spring Clip on Inlet Needle to metal float tab and
place needle into its seat.
51115
a
b
a - Spring Clip
b - Float Tab
• Install float into carburetor with float pin.
• Adjust float following “Carburetor Float Adjustment,”
Page 3A-13.
51115
b
a
a - Float
b - Float Pin
To Next Page
Loading...
