Battery Voltage Indicated:
No Voltage Indicated:
No Voltage Indicated:
Connect Voltmeter red lead to
Point 5. If battery voltage is indi-
cated, trim switch is faulty. If no bat-
tery voltage, check for loose or cor-
roded connection at Point 5 or
open circuit in wire supplying cur-
rent to Point 5.
UP Relay is defective. Replace and retest.
Connect Voltmeter red lead to
Point 7 and black lead to ground.
Depress “Down” trim button. If bat-
tery voltage is indicated, wire is
open between Points 7 and 8.
Connect Voltmeter red lead to
Point 8 and black lead to ground.
Depress the “Up” trim button.
5D-12 - MID-SECTION 90-817643R1 DECEMBER 1996
Troubleshooting the “Up” Circuit*
(When “Down” Circuit Is OK)
*Remote Control NOT Equipped with Trailer
Button
To Next Page
Loading...
