90-817643R1 DECEMBER 1996 MID-SECTION - 5B-33
IMPORTANT: When installing motor, wires (black,
orange) must rest in cavity of cylinder allowing
motor to seat properly.
51194
a
b
a - Manifold
b - Cavity
Reservoir Installation
1. Connect trim motor wires to harness.
2. Insert motor into reservoir. Motor must be seated
properly prior to end cap installation.
51196
3. Install end cap, O-ring and foam pad to cylinder.
4. Torque screws to 13 lb. ft. (1.5 N·m).
51195
a
b
c
a - End Cap
b - O-ring
c - Foam Pad
5. Install grommet, washer and screw cap to cylin-
der end cap. Tighten screw securely.
51195
a
b
c
a - Grommet
b - Washer
c - Screw Cap
To Next Page
Loading...
