5C-34 - MID-SECTION 90-8i7643R1 DECEMBER 1996
9. Secure reservoir to manifold using four screws.
Torque screws to 70 lb. in. (7.7 N·m).
51193
a
a
a - Screw
10. Install “E” clip, lubricated O-rings and to manual
release valve.
51196
a
b
c
a - “E” Clip
b - O-ring
c - Manual Release Valve
11. Insert manual release valve into manifold and
tighten snuggly. Back release valve out 3 or 4
turns allowing trim rod installation.
51194
a
b
a - Manual Release Valve
b - Manifold
Trim Rod Reassembly
1. Install lubricated O-rings and rod wiper to end
cap.
51145
b
c
a
a - Rod Wiper
b - Inner O-ring
c - Outer O-ring
2. Secure trim rod in soft jawed vise as shown.
3. Slide end cap onto trim rod.
51146
a
a - End Cap
To Next Page
Loading...
