7C-4 - OUTBOARD INSTALLATION/ATTACHMENTS 90-817643R1 DECEMBER 1996
Rewind Starter Disassembly
! WARNING
When disassembling and reassembling rewind start-
er, SAFETY GLASSES must be worn in case rewind
spring uncoils out of the housing.
1. Remove retaining clip and attaching screw which se-
cures shift interlock cable to starter housing.
2. Remove bolts (4) securing rewind starter to engine.
51606
b
c
a
c
cc
a - Retaining Clip
b - Screw
c - Bolts (4)
3. Slowly pull the starter rope out from the handle rest
approximately 2 feet (60 cm) and tie an overhand knot
between the rewind housing and the handle rest.
4. Remove retainer from rope handle and untie the rope
handle knot.
5. Remove the rewind starter.
a
b
a - Overhand Knot
b - Retainer
6. Remove cam retainer.
28374
a
b
a - Screws (3)
b - Cam Retainer
7. Remove cam lever, cam lever spring, and interlock le-
ver.
28375
a
b
c
a - Cam Lever
b - Cam Lever Spring
c - Interlock Lever
To Next Page
Loading...
