4-16 - POWERHEAD 90-817643R1 DECEMBER 1996
12. Install lifting eye (p/n 91-90455) into flywheel a mini-
mum of five turns. Lift powerhead from drive shaft
housing allowing shift linkage to slide off shift rail guide.
PE-51081
Powerhead Disassembly
Removing Engine Components
Remove the following engine components:
Component/Assembly Section
Starter Motor 2B
Ignition Switch Box 2A*
Ignition Coil 2A*
Starter Solenoid 2B*
Voltage Regulator/Rectifier 2B*
Flywheel 2A
Stator Assembly 2A*
Trigger Assembly 2A*
Air Attenuator 3A
Carburetor and Linkage 3A
Fuel Pump 3B
Fuel Enrichment valve 3C
Shift Cable Latch Assembly 7A
Control Cable Anchor Bracket 7A
Warning Module 3D*
Oil Pump 3D
*NOTE: all ignition and electrical components can be re-
moved and installed as an assembly.
1. Place powerhead in repair stand or on bench.
NOTE: Powerhead stand p/n 91-25821A1 can be used.
PE-51227a
To Next Page
Loading...
