Mercury 45 Jet 50-55 - Power Trim System Disassembly; Trim Rod Removal

5B-22 - MID-SECTION 90-817643R1 DECEMBER 1996
7. Tilt power trim assembly (top first) out from clamp
bracket and remove assembly.
51195
1
2
8. Remove fill cap and drain unit.
51193
9. Remove O-ring from fill cap.
51194
Power Trim System
Disassembly
Trim Rod Removal
1. Secure power trim assembly in soft jawed vise.
2. Open manual release valve three or four turns
(counterclockwise) and position trim rod to full up
position.
3. Remove cylinder end cap assembly from cylinder
using spanner wrench (1/4 in. x 5/16 in. long
pegs).
51194
a
a - Manual Release Valve