OUTBOARD INSTALLATION/ATTACHMENTS - 7B-2390-817643R1 DECEMBER 1996
4. Install rubber grommet to throttle cable and install into
bottom cowl. Note, a light lubricant on grommet will aid
in installation over shift rod.
51093
b
c
a
a - Rubber Grommet
b - Throttle Cable
c - Shift Rod
5. Adjust shift link rod and throttle cable “Shift Link Rod
Installation and Adjustment” and “Throttle Cable In-
stallation and Adjustment” as required.
Wiring Harness Connection
1. Remove battery cables from battery.
51084
2. Route wiring harness thru rubber grommet. Note, light
oil on rubber grommet will aid in wiring harness instal-
lation.
51095
b
a
a - Wiring Harness
b - Rubber Grommet
3. Connect handle wiring harness at engine harness con-
nector.
51091
b
a
a - Engine Harness Connector
b - Handle Harness Connector
To Next Page
Loading...
