MID-SECTION - 5C-3790-817643R1 DECEMBER 1996
Power Trim Unit Installation
1. Apply Special Lubricant 101 (92-13872A1) to
lower pivot pin hole and pivot pin surface.
2. Start lower pivot pin into pivot pin bore and posi-
tion lower dowel pin (RETAINED) in its respective
hole.
51148
b
a
a - Lower Pivot Pin
b - Lower Dowel Pin
3. Position trim cylinder assembly (BOTTOM
FIRST) between clamp brackets and route trim
pump electrical harness through access hole in
starboard clamp bracket.
51195
2
a
1
a - Trim Cylinder Assembly
4. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
51147
a
a - Lower Pivot Pin
5. Using a suitable punch, drive lower dowel pin into
its hole until seated.
51148
a
a - Lower Dowel Pin
To Next Page
Loading...
