6C-20 - LOWER UNIT 90-817643R1 DECEMBER 1996
Jet Drive Tiller Handle
Adaptor Kit
Installation Instructions
NOTE: This kit must be used in conjunction with the
recommended Quicksilver tiller handle kit.
1. Drill hole in bottom cowl for cable routing as fol-
lows:
a.
Locate the center lines for the hole following
the dimensions given in the illustration below.
Use a center punch to mark center of hole.
b.
Drill a 1/4 in. pilot hole and then a 9/16 in. hole
angling up into the bottom cowl.
1/2 in.
(12 mm)
Side View
Front View
5/8 in.
(16 mm)
2. Check to see if the shift cable will slide through the
drilled hole. If necessary, use a file to remove any
extra metal from the hole.
3. Install the shift cable to the jet drive. Use the exist-
ing mounting hardware supplied with the outboard.
Adjust shift cable after kit is installed.
a - Shift Cable
b - Bolt
c - Locknut
d - Flat Washer
To Next Page
Loading...
