5C-36 - MID-SECTION 90-8i7643R1 DECEMBER 1996
4. Install trim rod into cylinder.
51196
IMPORTANT: Memory piston must not come in
contact with trim rod end cap during end cap/trim
rod installation.
5. Tighten end cap assembly to cylinder securely
using trim cylinder spanner wrench (1/4 in. x 5/16
in. long pegs).
51145
6. Tighten manual release valve snuggly following
end cap installation.
Bleeding Power Trim Unit
IMPORTANT: Manual release valve must be in the
closed position during power trim bleeding and
operation.
1. Secure power trim unit in soft jawed vise.
2. Remove fill screw. Add Quicksilver Power Trim
and Steering Fluid (92-90100A12) or Automatic
Transmission Fluid (ATF) Type F, FA or Dexron II
up to threads of reservoir. Install cap.
50241
3. Using a 12 volt power supply connect positive
lead to green wire, negative lead to blue wire and
drive trim rod to the down position. Connect posi-
tive lead to blue wire and negative lead to green
wire and drive trim rod to the up position. Recheck
fluid level, add fluid if required and repeat cycle
until fluid level remains at lower portion of
threads.
To Next Page
Loading...
