Mercury 45 Jet 50-55 - Reservoir Assembly Removal

5C-26 - MID-SECTION 90-8i7643R1 DECEMBER 1996
2. Remove O-ring from end frame.
3. Place scribe mark on motor housing and end
frame as re-assembly reference, as shown.
51194
a
b
a - O-ring
b - Scribe Mark
4. Remove end frame and armature from housing.
51194
a
b
c
d
e
a - End Frame
b - Washer
c - Armature
d - Fiber Guard (Liner)
e - Housing
Reservoir Assembly Removal
CAUTION
DO NOT ADJUST OR REMOVE REVERSE
THRUST VALVE. THIS VALVE IS PRESET AT FAC-
TORY FOR PRECISE REVERSE THRUST PRES-
SURE AND DOES NOT REQUIRE ADJUSTMENT.
1. Remove manual release valve form manifold. DO
NOT remove or adjust reverse thrust valve.
a
b
51194
a - Manual Release Valve
b - Manifold
2. Remove “E” clip and O-rings from manual release
valve.
51196
a
b
c
a - “E” Clip
b - O-rings
c - Manual Release Valve