90-817643R1 DECEMBER 1996 MID-SECTION - 5B-35
Trim Rod Reassembly
1. Install lubricated O-rings and rod wiper to end
cap.
51145
b
c
a
a - Rod Wiper
b - Inner O-ring
c - Outer O-ring
2. Secure trim rod in soft jawed vise as shown.
3. Slide end cap onto trim rod.
51146
a
a - End Cap
4. Apply Loctite Grade A (271) to threads of trim rod
and install trim rod piston. Tighten piston securely
using spanner wrench (1/4 in. x 5/16 in. long peg).
51146
b
a
a - Trim Rod Piston
b - Spanner Wrench
5. Install lubricated O-ring to trim rod piston.
6. Install check ball components into its respective
bore.
7. Secure components in place using plate and
screws. Torque screws securely.
51147
b
c
d
e
f
a
a - Screw
b - Plate
c - O-ring
d - Ball
e - Seat, Spring
f - Spring
To Next Page
Loading...
