MID-SECTION - 5D-2390-817643R1 DECEMBER 1996
Reservoir Installation
1. Torque end cap screws to 13 lb. ft. (1.5 N·m).
51486
a
b
c
a - End Cap
b - O-ring
c - Screws (4)
2. Place drive shaft into oil pump.
3. Install lubricated O-ring to base of reservoir.
4. Carefully guide (with motor) down onto drive
shaft.
51486
a
b
a - Drive Shaft
b - O-ring
5. Secure reservoir to manifold using four screws.
Torque screws to 70 lb. in. (7.7 N·m).
51193
a
a
a - Screws (4)
6. Install lubricated O-rings and “E” clip to manual
release valve.
51196
a
b
c
a - “E” Clip
b - O-ring
c - Manual Release Valve
7. Insert manual release valve into manifold and
tighten snuggly. Back release valve out 3 turns
maximum allowing trim rod installation.
51194
a
b
a - Manual Release Valve
b - Manifold
To Next Page
Loading...
