MID-SECTION - 5D-1990-817643R1 DECEMBER 1996
3. Remove four screws securing reservoir to man-
ifold.
51193
a
a
a - Screws (4)
4. Remove reservoir from manifold.
5. Remove drive shaft from oil pump.
51486
a
b
c
a - Reservoir
b - Drive Shaft
c - Oil Pump
Manifold Removal
1. Remove screws and manifold from cylinder.
51007
a
b
c
a - Trim Cylinder
b - Manifold
c - Screw (2)
2. Remove check valve components from manifold.
IMPORTANT: Sleeve (d) is chamfered on I.D. on
end opposite drilled cross hole. Install spool (b)
(with O-ring installed) from chamfered end of
sleeve to avoid possibility of damaging O-ring on
spool.
d
e
c
b
a
51560
f
g
h
a - O-ring (0.114 I.D.)
b - Spool
c - O-ring (0.301 I.D.) (3 each)
d - Sleeve
e - Spring
f - Valve Seat
g - Valve
h - Spring
To Next Page
Loading...
