5B-32 - MID-SECTION 90-817643R1 DECEMBER 1996
Trim Motor Reassembly
1. Apply Quicksilver Marine Lubricant (2-4-C) to ar-
mature shaft and insert into end frame.
51195
a
b
c
a - Armature Shaft
b - Washer
c - End Frame
2. Guide armature and end frame into housing as
shown.
51196
3. Align scribe mark on housing with mark on end
frame.
4. Install lubricated O-ring to end frame.
51194
a
b
a - O-ring
b - Scribe Mark
5. Install washers to armature shaft as shown.
6. Install end cap to housing. Torque nuts to 25 lb. in.
(2.8 N·m).
51194
a
b
c
d
a - End Cap
b - Motor Housing
c - Wave Washer
d - Washer
To Next Page
Loading...
