Mercury 45 Jet 50-55 - Propeller Shaft Reassembly; Drive Shaft Wear Sleeve Installation

6B-22 - LOWER UNIT 90-817643R1 DECEMBER 1996
Propeller Shaft Reassembly
1. Install components into propeller shaft in
sequence shown.
19154
b
dc a
a - Spring
b - Guide Block
c - 3 Metal Balls*
d - Cam Follower*
*Hold in Place With Quicksilver 2-4-C w/Teflon
2. Install cross pin.
51800
b
a
a - Apply Pressure in This Direction
b - Cross Pin
3. Install spring. DO NOT overlap springs.
51876
a
a - Spring
Drive Shaft Wear Sleeve Installation
1. Install new rubber ring.
2. Apply a light coat of Loctite 271 on outside
diameter of rubber ring.
19152
a
a - Ring
3. Insert sleeve into holder*.
*Component of Wear Sleeve Installation Tool (91-14310A1).
19169
b
a
a
a - Sleeve
b - Holder