5D-24 - MID-SECTION 90-817643R1 DECEMBER 1996
Trim Rod Reassembly
1. Install lubricated O-rings and rod wiper to end
cap.
51145
b
c
a
a - Rod Wiper
b - Inner O-ring
c - Outer O-ring
2. Secure trim rod in soft jawed vise as shown.
3. Slide end cap onto trim rod.
51146
a
a - End Cap
4. Apply Loctite Grade A (271) to threads of trim rod
and install rod piston. Tighten piston securely us-
ing spanner wrench (1/4 in. x 5/16 in. long peg).
51146
b
a
a - Trim Rod Piston
b - Spanner Wrench
5. Install lubricated O-ring to trim rod piston.
6. Install check ball components into its respective
bore.
7. Secure components in place using plate and
screws. Torque screws to 35 lb. in. (4.0 N·m).
51147
b
c
d
e
f
a
a - Screw (3)
b - Plate
c - O-ring
d - Ball (5)
e - Seat, Spring (5)
f - Spring (5)
To Next Page
Loading...
